Jeep 2007 Grand Cherokee Manuel d'utilisateur télécharger pdf (Page 266)

100

101

LOW Indicator Lamp” in the instrument cluster will flash

and go out when the shift is complete. Release the

T-handle.

NOTE: If shift conditions/interlocks are not met, or a

transfer case motor temperature protection condition

exists, a “CHECK SHIFT PROCEDURES” message will

flash from the EVIC (Electronic Vehicle Information Cen-

ter). Refer to “Electronic Vehicle Information Center

(EVIC)” in Section 4 of this manual. (See page 183 for

more information.)

NOTE: Shifting into or out of 4WD LOW is possible

with the vehicle completely stopped, however difficulty

may occur due to the mating clutch teeth not being

properly aligned. Several attempts may be required for

clutch teeth alignment and shift completion to occur. The

preferred method is with the vehicle rolling 0 to 3 mph (0

to 5 km/h). If the vehicle is moving faster than 3 mph (5

km/h), the transfer case will not allow the shift.

Neutral (N) Shift Procedure

1. Key ON, engine off.

2. Vehicle stopped, with foot on brake.

3. Place transmission in N (Neutral).

4. Hold down N (Neutral) “pin” switch (with a pen, etc.)

for 4 seconds until the LED lamp by the switch starts to

blink indicating shift in progress. Lamp will stop blinking

(stay on solid) when Neutral shift is complete. A “4WD

SYSTEM IN NEUTRAL” message will display on the

EVIC (Electronic Vehicle Information Center). Refer to

“Electronic Vehicle Information Center (EVIC)” in Sec-

tion 4 of this manual. (See page 183 for more informa-

tion.)

266 STARTING AND OPERATING

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 471 472

Commentaires sur ces manuels

Pas de commentaire

Jeep 2007 Grand Cherokee Manuel d'utilisateur Page 266

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Jeep 2007 Grand Cherokee